Replacing M320 Packet Forwarding Engine Components; Figure 90: Installing A Sib - Juniper M320 Hardware Manual

M320 Router Hardware Guide
Related
Documentation

Replacing M320 Packet Forwarding Engine Components

174
Press the offline/online button until the green
7.
To verify that the SIB is functioning normally, check the LEDs on its faceplate. The
8.
green OK LED should light steadily a few minutes after the SIB is installed. If the
LED is lit steadily, remove and install the SIB again. If the
the SIB is not functioning properly. Contact your customer support representative.
To check the status of the SIBs, issue the following CLI command:
user@host> show chassis environment sib

Figure 90: Installing a SIB

M320 SIB Description on page 16
Maintaining the M320 SIBs on page 121
Preventing Electrostatic Discharge Damage to an M320 Router on page 214
Replacing an M320 FPC on page 175
Replacing an M320 PIC on page 180
Replacing M320 PIC Cables on page 184
Replacing an M320 SFP on page 187
Replacing an M320 XENPAK Module on page 190
LED blinks to bring the SIB online.
OK
LED still lights steadily,
FAIL
Copyright © 2010, Juniper Networks, Inc.
FAIL