Installing The Multi-Bin Output Tray - Gestetner B147 Service Manual

OPTIONAL UNIT

Installing the Multi-Bin Output Tray

NOTE: Before installing the multi-bin output tray, install the duplex unit.
1. Open the left cover [A] of the duplex
unit.
2. Install the ground plate [B] behind the
magnet.
3. Install the ground plate [C] on the rear
of the left cover.
4. Attach the ground plate to the top
cover, aligning the bottom edges of
the plate [D] and cover [E].
5. Attach the discharge brushes [F][G] to
the upper edges of the paper exits, so
that the ends of the brushes [H][I]
touch the ground plates [C][D]
respectively.
NOTE: Make sure the brushes do not
obstruct paper coming from
the exits.
6. Install the front [A] and rear [B] tray
holders on the top cover ( x 2 for
each).
7. Install the upper [C] and lower [D]
trays.
8. Turn the main switch on; select the SP
mode menu, SP6–901–1; and change
the multi-bin output tray setting.
NOTE: The multi-bin output tray is not
automatically recognized by the
printer mainframe. The multi-bin
output tray cannot be used until
you have changed this SP mode setting.
B147/B149/B190
[D]
[E]
[C]
[H]
[I]
[B]
1-38
[B]
G306I101.WMF
G306I102.WMF
[A]
G306I103.WMF
[D]
[A]
[F]
[G]
[C]
SM