Gestetner B147 Service Manual page 301

[Temperature Cor. 2] Fusing Temperature Correction (Temperature Setting)
1-914
Specifies the temperature to be subtracted from the targeted temperatures specified
in SP1-105-4 to-24.
Narrow: LT/A4 SEF width or less
Wide: Wider than LT/A4 SEF
1-914-1 Temp 1 185
1-914-2 Temp 1 125
1-914-3 Temp 1 62.5
1-914-4 Temp 1 OHP narrow
1-914-5 Temp 1 OHP wide
1-914-6 Temp 2 185
1-914-7 Temp 2 125
1-914-8 Temp 2 62.5
1-914-9 Temp 2 OHP narrow
1-914-10 Temp 2 OHP wide
1-915 [Stand-by Time]
1-915-1 Job Receiving
Specifies the time to shift the machine into the stand-by mode when not receiving a
print start command after receiving a print preparation command.
1-915-2 Job End
Specifies the time to shift the machine into the stand-by mode after the last job is
completed.
1-916 [Idling Mode]
1-916-1 Mode Set
Executes the extra idling operation after the fusing unit becomes ready just after the
main switch has been turned on.
1-916-2 Idling Time
Specifies how long the extra idling operation is executed.
1-916-3 PreJob Mode
Executes the extra idling operation after the fusing unit becomes ready when a print
job arrives at the copier.
1-916-4 Idling Time
Specifies how long the extra idling operation is executed when special paper is used
and the line speed is 185 mm/s.
SM
*BCU
[ 0 to 20 / 0 / 5°C /step ]
*BCU
[ 0 to 20 / 5 / 5°C /step ]
*BCU
[ 0 to 20 / 0 / 5°C /step ]
*BCU
[ 0 to 20 / 5 / 5°C /step ]
*BCU
[ 0 to 20 / 5 / 5°C /step ]
*BCU
[ 0 to 20 / 10 / 5°C /step ]
*BCU
[ 0 to 20 / 10 / 5°C /step ]
*BCU
[ 0 to 20 / 10 / 5°C /step ]
*BCU
[ 0 to 20 / 5 / 5°C /step ]
*BCU
[ 0 to 20 / 5 / 5°C /step ]
*BCU [ 0 to 180 / 60 / 10 seconds/step ]
0: The machine does not shift to the stand-by
mode.
*BCU [ 0 to 180 / 30 / 10 seconds/step ]
0: The machine does not shift to the stand-by
mode.
*BCU [ 0 to 1 / 0 / 1 /step ]
0: Off
1: On
*BCU [ 10 to 120 / 30 / 10 sec/step ]
*BCU [ 0 to 1 / 0 / 1 /step ]
0: Off
1: On
*BCU [ 0 to 360 / 0 / 1 sec/step ]
5-13
COPY SERVICE MODE
B147/B149/B190