COPY SERVICE MODE
5-801-5
MCS
Clears MCS data. DFU
5-801-6
Copier Application
Clears the copy application settings.
5-801-7
Fax Application
Clears the fax application settings.
5-801-8
Printer Application
Clears the printer application settings.
5-801-9
Scanner Application
Clears the scanner application settings.
5-801-10
Network Application
Delete the netfile application management files and thumbnails, and initializes the
job login ID.
5-801-11
NCS
Initializes the system default and interface settings (IP address also),
SmartNetMonitor for
Admin, WebStatusMonitor settings, and the TELNET settings.
5-801-12 R-FAX
Initializes the job login ID, SmartNetMonitor for
Admin, job history, and local storage file numbers.
5-801-13 IPU
Clears the IPU settings
5-801-14 Clear DCS Settings
5-801-15 Clear UCS Settings
5-802
EngineFreeRun
5-802-1
EngineFreeRun
Performs a free run on the copier engine.
NOTE:
•
The machine starts free run in the same condition as the sequence of A4/LT
printing from the 1st tray. Therefore, paper should be loaded in the 1st tray, but
paper is not fed.
•
The main switch has to be turned off and on after using the free run mode for a
test.
5-803
[Input Check]
5-804
[Output Check]
5-808
[Destination Code] Destination Code Display
Displays the destination code.
5-808-1 Destination
5-809
[SC Detection ON/OFF] SC Detection ON/OFF
Enable or disables the service call detection (SC codes will be ignored if disabling
this SP mode).
5-809-1 All
5-809-2 Vib Motor
B147/B149/B190
See section 5-3-2.
See section 5-3-3.
*BCU
*BCU
[ 0 or 1 / 0 / - ] Alphanumeric
0: Enable
1: Disable
5-46
SM