Gestetner B147 Service Manual page 917

SP IFAX SW
1102 2 01
Bits 0~ 6: Original Line Resolution of TX Attachment File
This setting sets the maximum resolution of the original that the destination can
receive.
0: Not selected
1: Selected
Note: If more than one of these three bits is set to "1", the higher resolution has
priority. For example, if both Bit 3 and Bit 2 are set to "1" then the resolution is set for
"Reserve (300 x 300)" (Bit 3).
Bit 6
Reserved Reserved
When mail is sent, there is no negotiation with the receiving machine at the
destination, so the sending machine cannot make a selection for the receiving
capabilities (resolution setting) of the receiving machine.
The resolution selected with this switch is used as the RX machine's resolution
setting, and the original resolution is converted before sending.
The default is both 200 x 100 and 200 x 200 are selected.
If the resolution set with this switch is higher than the receiving fax can accept, the
machine detects this and this causes an error.
Note: The "1" setting requires installation of the Function Upgrade Card in order to
have enough SAF (Store and Forward) memory to receive images at 400 x 400
resolution.
Bit 7: mm/inch
This setting selects mm/inch conversion for mail transmission.
0: Off (No conversion)
1: On (Conversion)
When on (set to "1"), the machine converts millimeters to inches for sending mail.
There is no switch for converting inches to millimeters.
Note: Unlike G3 fax transmissions which can negotiate between sender and receiver
to determine the setting, mail cannot negotiate between terminals; the mm/inch
selection is determined by the sender fax.
Only two choices are available for transmission: inch statements and inch images, or
inch statements and mm images.
When this switch is Off (0):
• Images scanned in inches are sent in inches.
• Images scanned in mm are sent in mm.
• Images received in inches are transmitted in inches.
• Images received in mm are transmitted in mm.
When this switch is On (1):
• Images scanned in inches are sent in inches.
• Images scanned in mm are converted to inches.
• Images received in inches are transmitted in inches.
• Images received in mm are converted to inches.
SM
Bit 5 Bit 4
400 x 400 Reserved
Super Fine
11
SP1102 IFAX SWITCH
Bit 3 Bit 2 Bit 1
200x400 200x200
Fine Detail
Bit 0
200x100
Standard
IFAX