Gestetner B147 Service Manual page 297

[Dev. Motor Speed4] Development Drive Motor Speed 4
1-007
Adjusts the development motor speed for postcards.
1-007-1 [CL] Mail TH
1-008 [Drum STM Speed] Drum STM Speed Adjustment
Adjusts the drum speed of each line-speed mode (62.5 mm/s and 125 mm/s); this
adjusts drum speed but not transfer belt speed.
1-008-1 [CL] 62.5
1-008-2 [CL] 125
1-008-3 [Bk] 62.5
1-008-4 [Bk] 125
1-008-5 OHP
1-008-6 MUSIC
1-104 [Fusing Control]
1-104-1 Control Method
Selects the fusing control method.
NOTE: This mode can be used only for N. America models
1-104-25 Process Speed
Selects the power-on default target fusing operation temperature.
The target operating fusing temperature depends on the process speed. When the
machine is switched on, it starts warming up for the process speed specified in this
SP mode.
1-105 [Fusing Temperature]
(Heating or Pressure roller: Paper Type, [Color], Simplex/Duplex, Process Speed)
Paper Type -> N: Normal, OHP. TH: Thick, SP: Special
Some settings of fusing temperature depend on the destination (US or Europe/Asia).
US: Setting for US, EU: Setting for Europe/Asia
1 105-1 H: Ready
Sets the heating roller temperature for the printing ready condition.
After the main switch has been turned on, the machine enters the print ready
condition when the heating roller temperature reaches the temperature specified in
this SP mode.
When the machine is in the recovery mode from the energy saver or auto off mode,
the machine becomes ready when both heating and pressure roller temperatures
reach the specified temperature.
Ready temperature = (Target temperature specified in SP1-104-25 or 105-3 to 28) –
Temperature specified in this SP mode.
SM
*BCU [ -1.00 to 0.00 / -0.40 / 0.05%/step]
*BCU [ 0 to 10/ 7 / 1 /step ] DFU
*BCU [ 0 to 10/ 7 / 1 /step ] DFU
*BCU [ 0 to 10/ 5 / 1 /step ] DFU
*BCU [ 0 to 10/ 3 / 1 /step ] DFU
*BCU [ 0 to 10/ 3 / 1 /step ] DFU
*BCU [ 0 to 10/ 3 / 1 /step ] DFU
*BCU [ 0 or 1 / 0 / - ] Alphanumeric
0: ON/OFF Control
1: Phase Control
*BCU [0 to 4 / 4 / 1/step] Alphanumeric
0: Color 62.5 mm/s (temperature specified by
SP 1-105-8 and 19)
1: Color 125 mm/s (temperature specified by
SP 1-105-9 and 20)
2: Thick / OHP (temperature specified by SP 1-
105-13 and 24)
3: K 125 mm/s (temperature specified by SP 1-
105-4 and 15)
4: K 185 mm/s (temperature specified by SP 1-
105-5 and 16)
*BCU [ 10 to 100 / 10 / 1
5-9
COPY SERVICE MODE
o
C/step ]
B147/B149/B190