Gestetner B147 Service Manual page 93

[B]
[D]
[F]
[A]
3. Pull off the edge connector protector [A] off the card and discard it.
4. With the card label facing left, insert the card [B] into the PCI slot.
5. Use the Velcro pads to install the antennas [C] on the left rear corner of the
machine.
NOTE: The antennas should be separated by at least 40 ~ 60 mm (1.5~2.5").
Always detach the antennas from the corners of the machine and
disconnect them before moving the machine.
6. Connect the antennas to the terminals [D].
7. Wrap the cables [E] and hang them over the antennas as shown.
8. Attach the cover [F] ( x 2).
9. If reception is poor, you may need to move the machine:
• Make sure that the machine is not located near an appliance or any type of
equipment that can generate a strong magnetic field.
• Position the machine as close as possible to the access point.
SM
[C]
B582I902.WMF
1-59
OPTIONAL UNIT
[E]
B147/B149/B190