Up Mode Settings For Ieee 1394; Sp Mode Settings For Ieee 1394 - Gestetner B147 Service Manual

UP Mode Settings for IEEE 1394

Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 1394. These settings take effect every time the machine is
powered on.
1. Press the User Tools/Counter  key.
2. On the touch panel, press System Settings.
3. Press Interface Settings.
4. Press the corresponding key to enter the following settings:
• IP Address
• Subnet Mask
• IP Over 1394. Enable or disable this setting as required. This setting enables
IP Over 1394 as the default setting for the printing method.
• SCSI Print. Enable or disable this setting as required. This setting enables
SCSI Print as the default setting for the printing method.
• SCSI Print Bi-directional. Switch bi-directional printing on or off for SCSI print.

SP Mode Settings for IEEE 1394

The following SP commands can be set for IEEE 1394.
SP No. Name
5-839 004 Host Name
5-839 007 Cycle Master
5-839 008 BCR Mode
5-839 009 IRM 1394a
Check
5-839 010 Unique ID
5-839 011 Logout
5-839 012 Login
5-839 013 Login MAX
SM
Function
Sets the name of the device used on the network.
Example: RNPXXXXXXXXXX
Enables or disables cycle master function of the IEEE
1394 standard bus.
Sets the BCR (Broadcast Channel Register) setting for
the Auto Node operation for the standard IEEE1394 bus
for when IRM is not in use. The following three settings
are available: "Standard," "IRM Color Copy," and
"Always Effective."
Determines whether an IRM check for IEEE 1394a is
conducted for the Auto Node when IRM is not used.
Enables the "Node_Unique_Id" setting for enumeration
on the standard IEEE 1394 bus.
Determines how successive initiator login requests are
handled during login in for SBP-2.
Enables or disables exclusive login for SBP-2.
Sets the limit for the number of logins for SBP-2. Range:
1 ~ 62.
1-55
OPTIONAL UNIT
B147/B149/B190