Gestetner B147 Service Manual page 814

ERROR CODES
Code Meaning
5-23 Print data error when
printing a substitute rx or
confidential rx message
5-24 Memory overflow after the
second page of a scanned
document
5-25 SAF file access error
6-00 G3 ECM - T1 time out
during reception of facsimile
data
6-01 G3 ECM - no V.21 signal
was received
6-02 G3 ECM - EOR was
received
6-04 G3 ECM - RTC not detected
6-05
G3 ECM - facsimile data
frame not received within 18
s of CFR, but there was no
line fail
6-06 G3 ECM - coding/decoding
error
6-08 G3 ECM - PIP/PIN received
in reply to PPS.NULL
6-09 G3 ECM - ERR received
6-10 G3 ECM - error frames still
received at the other end
after all communication
attempts at 2400 bps
6-21
V.21 flag detected during
high speed modem
communication
6-22 The machine resets the
sequence because of an
abnormal handshake in the
V.34 control channel
6-99 V.21 signal not stopped
within 6 s
B603
Suggested Cause/Action
• Test the SAF memory.
• Ask the other end to resend the message.
• Replace the FCU or optional EXMEM board.
• Try using a lower resolution setting.
• Wait for the messages which are currently in the
memory to be sent or delete some files from
memory.
• Replace the FCU or EXMEM board.
• Try adjusting the rx cable equalizer.
• Replace the FCU or NCU.
• Check the line connection.
• Check connections from the NCU to the FCU.
• Check for a bad line or defective remote terminal.
• Replace the FCU or NCU.
• Check the line connection.
• Check connections from the NCU to the FCU.
• Check for a bad line or defective remote terminal.
• Replace the FCU or NCU.
• Try adjusting the rx cable equalizer
Cross reference
• Rx cable equalizer - G3 Switch 07 (PSTN)
• Defective FCU.
• The other terminal may be defective.
• The other end pressed Stop during
communication.
• The other terminal may be defective.
• Check for a noisy line.
• Adjust the tx levels of the communicating
machines.
• See code 6-05.
• Check for line noise.
• Adjust the tx level (use NCU parameter 01 or the
dedicated tx parameter for that address).
• Check the line connection.
• Defective remote terminal.
• The other terminal may be defective or
incompatible.
• Check for line noise.
• If the same error occurs frequently, replace the
FCU.
• Defective remote terminal.
• Replace the FCU.
20 SM