Service Tables; Service Program Mode; Service Program Mode Operation; Entering And Exiting Sp Mode - Gestetner B147 Service Manual

3. SERVICE TABLES


CAUTION
Never turn off the main power switch when the power LED is lit or flashing.
To avoid damaging the hard disk or memory, press the operation power
switch to switch the power off, wait for the power LED to go off, and then
switch the main power switch off.
NOTE: The main power LED lights or flashes while the platen cover or ARDF is
open, while the main machine is communicating with a facsimile or the
network server, or while the machine is accessing the hard disk or memory
for reading or writing data.

3.1 SERVICE PROGRAM MODE

3.1.1 SERVICE PROGRAM MODE OPERATION

The service program (SP) mode is used to check electrical data, change modes,
and adjust values.

Entering and Exiting SP mode

 Press the Clear Mode key.
1
.
 Use the keypad to enter "107".
2
.
 3 Hold down Clear/Stop for at least 3 seconds.
.
Fax SP
4 On the touch-panel, press Fax SP.
.
Press Exit twice to return to the copy window.
5
Exit
.
SM
SERVICE PROGRAM MODE
23 B603