Gestetner B147 Service Manual page 333

5-508-12*
Jam Detection: Continuous
Count
Sets the number of consecutive paper jams required to initiate a call. This setting is
enabled only when SP5508 004 is set to 1.
5-508-13* Door Open: Time Length
Sets the length of time the door remains open before the machine initiates a call.
This setting is enabled only when SP5508 004 is set to 1.
5-508-21* Jam Operation: Time Length
Determines what happens when a paper jam is left unattended.
5-508-22* Jam Operation: Continuous
Count
Determines what happens when consecutive paper jams occur.
5-508-23* Door Operation: Time Length
Determines what happens if the door remains open (15 min.).
Displays a warning if set to ON. Pressing the call button will contact the service
center. This setting is available for setting only if SP5508 004 is set for 1.
5-610 [ACC Factory Setting]
5-610-4 Recall
Recalls the factory settings.
5-610-5 Overwrite
Overwrites the current values onto the factory settings.
5-610-6 Previous Setting
Recalls the previous settings.
5-611 [Toner Ratio in 2C]
Adjusts the color balance of a single color (blue, green, or red) by changing the
proportion of color toner (C, M, and/or Y).
5-611-1 B-C
5-611-2 B-M
5-611-3 G-C
5-611-4 G-Y
5-611-5 R-M
5-611-6 R-Y
5-801 [Memory Clear]
NOTE: For more information, see "NOTE 1" following this table.
5-801-1 All Clear
Resets all correction data for process control and all software counters, and
returns all modes and adjustments to their default values.
To execute, hold down  for over 3 seconds, and then turn the copier off and
on again.
Use this SP only after replacing the NVRAM, or after the copier has
malfunctioned due to a damaged NVRAM.
5-801-2 ENG All
Initializes items 2 ~ 12 below.
5-801-3 SCS
Clears the system settings.
5-801-4 IMH Memory Clr
Clears IMH data. DFU
SM
[02~10 / 5 / 1]
[03~30 / 10 / 1]
0: Automatic Call
1: Audible Warning at Machine
0: Automatic Call
1: Audible Warning at Machine
0: OFF, 1: ON
*CTL [ 0 to 100 / 90 / 1 %/step ]
[ 0 to 100 / 80 / 1 %/step ]
[ 0 to 100 / 90 / 1 %/step ]
[ 0 to 100 / 80 / 1 %/step ]
[ 0 to 100 / 100 / 1 %/step ]
[ 0 to 100 / 80 / 1 %/step ]
5-45
COPY SERVICE MODE
B147/B149/B190