Code
Meaning
2-12
Modem clock irregularity
2-13
Modem initialization error
2-20
Abnormal coding/decoding
(cpu not ready)
2-23
JBIG compression or
reconstruction error
2-24
JBIG ASIC error
2-25
JBIG data reconstruction
error (BIH error)
2-26
JBIG data reconstruction
error (Float marker error)
2-27
JBIG data reconstruction
error (End marker error)
2-28
JBIG data reconstruction
error (Timeout)
2-50
The machine resets itself for
a fatal FCU system error
2-51
The machine resets itself
because of a fatal
communication error
4-01
Line current was cut
4-10
Communication failed
because of an ID Code
mismatch (Closed Network)
or Tel. No./CSI mismatch
(Protection against Wrong
Connections)
5-00
Data construction not
possible
5-01
Data reconstruction not
possible
5-10
DCR timer expired
5-20
Storage impossible because
of a lack of memory
5-21
Memory overflow
5-22
Mode table overflow after
the second page of a
scanned document
SM
Suggested Cause/Action
• Replace the FCU.
• Turn off the machine, then turn it back on.
• Update the modem ROM.
• Replace the FCU.
• Replace the FCU.
• Turn off the machine, then turn it back on.
• Replace the EXFUNC board if the error is
frequent.
• Turn off the machine, then turn it back on.
• Replace the EXFUNC board if the error is
frequent.
• JBIG data error
• Check the sender's JBIG function.
• Update the MBU ROM.
• If this is frequent, update the ROM, or replace the
FCU.
• If this is frequent, update the ROM, or replace the
FCU.
• Check the line connector.
• Check the connection between FCU and NCU.
• Check for line problems.
• Replace the FCU or the NCU.
• Get the ID Codes the same and/or the CSIs
programmed correctly, then resend.
• The machine at the other end may be defective.
• Replace the FCU.
• Temporary memory shortage.
• Test the SAF memory.
• Replace the FCU or optional EXMEM board
• Wait for the messages which are currently in the
memory to be sent or delete some files from
memory.
19
ERROR CODES
B603