Gestetner B147 Service Manual page 104

OPTIONAL UNIT
9. Install the switch bracket (with the
heater switch) to the original place. Do
not fasten the screws yet.
10. Connect the white connectors to the
switch.
11. Insert the red connector [A] into the
opening on the frame [B].
12. Fasten the two screws on the switch bracket.
13. Align the caution decal [E] with the
mark [F] on the front of the heater
cover [G], and attach the caution
decal there.
14. Align the tray heater [H] with the
marks [I][J] on the back of the
heather cover, and attach the tray
heater there.
15. Connect the tray heater connector
[K] (from the front side of the
copier) to the red connector [A].
16. Insert the heater cover to the
openings [C][D] from the front side
( x 1).
NOTE: The connectors [A][K] are
under the heater-tray cover.
17. Reassemble the copier and install
tray 1 and tray 2.
18. Attach the "On/Stand by" decal on
the left-hand side of the main switch
(not the tray heater switch).
B147/B149/B190
[B]
[C]
[E]
[F]
[H]
[K]
[I]
On
Stand by
1-70
[D]
[J]
[A]
B146I949.WMF
[G]
B146I950.WMF
B146I951.WMF
B146I952.WMF
SM