Gestetner B147 Service Manual page 802

G3 INTERFACE UNIT
[D]
3. Install the four spacers [A] to the rear of the fax-controller unit.
4. Install the interface board [B] on the spacers.
5. Install the flat cable [C] to the interface board.
6. Connect the flat cable to the fax-controller board [D] (the connector is on the
front of the fax-controller board).
7. Connect the G3 board [E] to the interface board ( x 2).
NOTE: See the diagram above and connect the G3 board to the correct slot.
Leave the other slot open–this slot is used by some local models.
8. Connect the cable [F] to the G3 board.
NOTE: The core [G] is on an end of the cable. Connect this end to the G3
board.
B603
[C]
[A]
8
[B]
[E]
[G]
[F]
B604I903.WMF
SM