Gestetner B147 Service Manual page 826

BIT SWITCHES
Width and
reduction
I/O rate
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02
No FUNCTION
0 Not used
to
1
2 Communication error reset
3 Not used
4 File retention time
0: Depends on User Parameter
24 [18(H)]
1: No limit
5 Not used
6
Memory read/write by RDS
to Bit 7 6
7 0 0
0 1
1 0
1 1
B603
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
0: 0 ms/line
25: 2.5 ms/line
5: 5 ms/line
Note:
"40" is displayed while receiving a fax message using AI short
protocol.
Do not change the setting.
0: OFF/1: ON
Bit 2 turns on or off the communication error reset
switch. When this switch is on, the system forcefully
terminates the job under the following conditions:
1. A communication job has started, and
2. The job does not end within an hour.
After terminating the job, the system goes back to
the ready status. When this switch is on, the system
can automatically recover from a communication
error. You cannot adjust the timer for the second
condition above.
Do not change the setting.
1: A file that had a communication error will not be
erased unless the communication is successful.
Do not change the setting.
(0,0): All RDS systems are always locked out.
Setting (0,1), (1,0): Normally, RDS systems are locked out,
Always disabled but the user can temporarily switch RDS on to allow
User selectable RDS operations to take place. RDS will
User selectable automatically be locked out again after a certain
Always enabled time, which is stored in System Switch 03. Note that
if an RDS operation takes place, RDS will not switch
off until this time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
10: 10 ms/line
20: 20 ms/line
40: 40 ms/line
COMMENTS
32
SP No. 1-101-003
SM