Front Scanner Wire - Gestetner B147 Service Manual

SCANNER UNIT

3.6.8 FRONT SCANNER WIRE

1. Front frame (
2. Front scanner wire clamp [A]
3. Front scanner wire bracket [B]
( x 1)
4. Front scanner wire and scanner
drive pulley [C] ( x 1)
Reassembling the Front Scanner Wire
1. Position the center ball [A]
in the middle of the forked
holder.
2. Pass the right end (with
the ring) [B] through the
square hole, and the left
end (with the ball) [C]
through the notch.
3. Wind the right end
clockwise (viewed from the
machine's front) three
times; wind the left end
counterclockwise five
times.
NOTE: The two red marks [D] meet when you have done this. Stick the wire to
the pulley with tape, so you can handle the assembly easily during
installation.
B147B149/B190
3.6.5)
[C]
[B]
[A]
[A]
[D]
3-26
[B]
B146R140.WMF
[C]
B146R141.WMF
SM