Nvram On Controller - Gestetner B147 Service Manual

8. Turn the main switch off and on.
9. Copy the data from the SD card to the NVRAM (
successfully copied them to the SD card.
10. Reset the settings for meter charge (
11. Specify the SP and UP mode settings.
12. Execute the process control self-check.
13. Perform ACC for the copier application program.
14. Perform ACC for the printer application program.

NVRAM on Controller

1. Make sure that you have the SMC report (factory settings) that comes with the
copier.
2. Output the SMC data (
3. Copy the NVRAM data to an SD card (
4. Enter SP mode and print out the SMC reports (
5. Turn off the main switch and unplug the power cord.
6. Replace the NVRAM on the controller and reassemble the machine.
7. Turn the main switch on.
8. Copy the data from the SD card to the NVRAM (
successfully copied them to the SD card.
9. Specify the SP and UP mode settings.
10. Perform ACC for the copier application program.
11. Perform ACC for the printer application program.
SM
SP5-930-002).
SP5-990-001) if possible.
SP5-824) if possible.
3-73
ELECTRICAL COMPONENTS
SP5-825-001) if you have
SP5-990-001) if possible.
SP5-825-001) if you have
B147/B149/B190