Gestetner B147 Service Manual page 343

5-848-8 Access Ctrl: Comm. Log Scan
(Lower 4 bits)
5-848-9 Access Ctrl: Job Ctrl (Lower 4
bits)
5-848-11 Access Ctrl: Device Ctrl Sys
(Lower 4 bits)
5-848-12 Access Ctrl: Device Ctrl Copy
(Lower 4 bits)
5-848-13 Access Ctrl: Device Ctrl Fax
(Lower 4 bits)
5-848-14 Access Ctrl: Device Ctrl Printer
(Lower 4 bits)
5-848-15 Access Ctrl: Device Ctrl
Scanner (Lower 4 bits)
5-848-21 Access Ctrl: Delivery (Lower 4
bits)
5-848-100 Repository: max size of
download image
5-849 Installation Date
5-849-1 Display
5-849-2 Switch to Print
5-850 Address Book Function
5-850-3 Replacement of Circuit Classification
The machine is sold ready to use with a G3 line. This SP allows you to switch all at
once to convert to G4 after you add a G4 line. Conversely, if for some reason the
G4 line becomes unusable, you can easily switch back to G3.
5-853 Stamp Data Download
Use this SP to download the fixed stamp data stored in the firmware of the ROM
and copy it to the HDD. This SP can be executed as many times as required. This
SP must be executed after replacing or formatting the hard disks.
Note: This SP can be executed only with the hard disks installed.
5-856 [Remote ROM Update]
Allows the technician to upgrade the firmware using a parallel cable
5-856-2 Local Port
5-857 Debug Log Save Function
5-857-1 On/Off (1:ON 0:OFF)
Switches the debug log feature on and off. The debug log cannot be captured until
this feature is switched on.
5-857-2 Target (1:IC Card 2:HDD)
Select "1" (IC Card) if an HDD unit is not installed in the machine, or if the HDD unit
is temporarily out of service. The IC card can store only 4 MB so use the HDD
selection.
SM
Switches access control on and off.
0000: OFF
[1 to 1024 / 1024 / 1/K]
*CTL
DFU
DFU
*CTL Japan Only
*CTL [ 0 to 1 / 0 / 1/step]
0: Disable
1: Enable
*CTL
0: ON, 1: OFF
1:IC Card, 2:HDD
5-55
COPY SERVICE MODE
B147/B149/B190