Gestetner B147 Service Manual page 353

6-016-1 Original Size Priority
6-017 [DF Magnification Adj.] DF Magnification Adjustment
Adjusts the magnification in the sub-scan direction for the ARDF.
6-017-1 DF Magnification Adj.
6-110 [Punch Position]
Adjusts the punching position.
Punch 1
US: 2 punch holes
Europe: 2 punch holes
North Europe: 4 punch holes
Punch 2
US: 3 punch holes
Europe: 4 punch holes
Increment: Holes move toward the paper center.
Decrement: Holes move toward the paper edge.
6-110 1 MF Fin 1
6-110 2 MF Fin 2
6-110 3 Booklet Fin
6-111 [Staple Position]
Adjusts the stapling position.
Increment: Staple position moves toward the edge of paper.
Decrement: Staple position moves toward the center of paper.
NOTE: Although the adjustable range is ±3.5 mm, the stapling position can be
changed only by 1.0 mm when stapling one position at the front or rear side even
when the input value is more than 1.0.
6-111-1 MF Fin
6-111-2 Booklet Fin
6-112 [Fold Position]
SM
*CTL [ 0 or 1 / 0 / - ]
0: Setting 1
1: Setting 2
Setting 1
Bit 7 A4 (L)
Bit 6 11" x 15"
Bit 5 DLT (L)
Bit 4 LT (S)
Bit 3 LT (L)
Bit 2 LG (L)
Bit 1 A4 (L)
Bit 0 8K (L)
Bits used for detection differ depending on
destination as shown below.
Bit 7 to 6: Only for Japan
Bit 5 to 2: Only for US
Bit 1 to 0: Only for EU/AA
*CTL [ -5.0 to 5.0 / 0 / 0.1 %/step ]
*BCU [ -7.5 to 7.5 / 0 / 0.5 mm/step ]
*BCU
[ -2.5 to 7.5 / 0 / 0.5 mm/step ]
*BCU [ -3.5 to 3.5 / 0 / 0.5 mm/step ]
[ -3.75 to 3.75 / 0. / 0.25 mm/step ]
*BCU [ -3.75 to 3.75 / 0. / 0.25 mm/step ]
5-65
COPY SERVICE MODE
Setting 2
LT (L)
DLT (L)
11" x 15"
US Exec (S)
8" x 10" (L)
F4 (L)
16K (L)
DLT (L)
B147/B149/B190