Figure 5-3 Lacp Configuration Instance - Zte ZXR10 2900E series Configuration Manual

Figure 5-3 LACP Configuration Instance

l
Configuration Procedure
1. The detailed configuration of switch A is as follows:
zte(cfg)#set lacp enable
zte(cfg)#set lacp aggregator 3 add port 15-16
zte(cfg)#set lacp aggregator 3 mode dynamic
zte(cfg)#set lacp load-balance packet L2
zte(cfg)#set vlan 2 add trunk 3 tag
zte(cfg)#set vlan 2 add port 1 untag
zte(cfg)#set vlan 3 add trunk 3 tag
zte(cfg)#set vlan 3 add port 3 untag
zte(cfg)#set port 1 pvid 2
zte(cfg)#set port 3 pvid 3
zte(cfg)#set vlan 2-3 enable
2. The detailed configuration of switch B is as follows:
zte(cfg)#set lacp enable
zte(cfg)#set lacp aggregator 3 add port 15-16
zte(cfg)#set lacp aggregator 3 mode dynamic
zte(cfg)#set lacp load-balance packet L2
zte(cfg)#set vlan 2 add trunk 3 tag
zte(cfg)#set vlan 2 add port 2 untag
zte(cfg)#set vlan 3 add trunk 3 tag
zte(cfg)#set vlan 3 add port 4 untag
zte(cfg)#set port 2 pvid 2
zte(cfg)#set port 4 pvid 3
zte(cfg)#set vlan 2-3 enable
l
Configuration Verification
The results of implementing the following command on the two switches are similar.
zte(cfg)#show lacp
Lacp is enabled.
Lacp priority is 32768.
Load-balance is based on L2 hash mode.
SJ-20130731155059-002|2013-11-27 (R1.0)
Chapter 5 Service Configuration
5-19
ZTE Proprietary and Confidential