Zte ZXR10 2900E series Configuration Manual page 45

.................................................
.................................................
7,384,016 bytes downloaded
zte(cfg-tffs)#ls
zte(cfg-tffs)#ls
/img/
.
..
zImage
7. Restart the switch. After successful startup, check the operating version and confirm
whether the upgrade is successful.
Upgrading the Version When the System is Abnormal
If the switch cannot be started normally or runs abnormally, upgrade the version as follows:
1. Connect the console port of the switch to the serial port of the back-end computer by
using a provided configuration cable. Connect an Ethernet port of the switch to the
network port of the back-end computer by using a network cable. Ensure that the
connections are correct.
2. Restart the switch. On the HyperTerminal, press any key as prompted to enter ZXR10
Boot status.
ZXR10 2928E BootRom Version v1.08
Compiled Feb 27 2012 10:32:29
Copyright (c) 2010 by ZTE Corporation.
boot location [0:Net,1:Flash] : 0
actport
serverip
netmask
ipaddr
bootfile
username
password
MAC
[ZXR10 Boot]
3. Enter c in ZX10 Boot status and press Enter to enter the parameter modification status.
Set the IP addresses of the Ethernet port and the TFTP server. The two addresses
are set to be in the same network segment.
[ZXR10 Boot]: c
boot location [0:Net,1:Flash] : 0
/*start by tftp or Flash */
actport
/*select the port enabled by tftp*/
serverip
/*ftp/tftp server address*/
SJ-20130731155059-002|2013-11-27 (R1.0)
7,536,884 bytes
240,568,768 bytes free
: 1
: 10.40.89.78
: 255.255.255.0
: 10.40.89.100
: /img/zImage
: ZXR10
: 123456
: 00:d0:d0:3c:3b:00
: 1
: 10.40.89.78
4-13
Chapter 4 System Management
<DIR>
<DIR>
ZTE Proprietary and Confidential