Figure 5-17 Layer-3 Configuration Instance - Zte ZXR10 2900E series Configuration Manual

Command
show ipport [<0-63>](all configuration modes)
show iproute (all configuration modes)
show hardware-iproute (all configuration modes)
IPv4 Layer 3 Configuration Instance
l
Configuration Description
Set the layer-3 IP address to 192.168.1.2 on the switch. The IP address 192.168.1.2
can ping the IP address 192.168.1.1 successfully. Bind vlan100 with 192.168.1.2.
Port 1 on switch connects with PC. See

Figure 5-17 Layer-3 Configuration Instance

l
Configuration Procedure
zte(cfg)#set vlan 100 enable
zte(cfg)#set vlan 100 add port 1
zte(cfg)#set port 1 pvid 100
zte(cfg)#config route
zte(cfg-router)#set ipport 0 ipaddress 192.168.1.2 255.255.255.0
zte(cfg-router)#set ipport 0 vlan 100
zte(cfg-router)#set ipport 0 enable
l
Configuration Verification
zte(cfg-router)#show ipport
IpPort En/Disable IpAddress
------ ---------- ------------ -------------- ----------------- ------
0
zte(cfg-router)#exit
Use the ping command to check whether the layer-3 port is available.
zte(cfg)#ping 192.168.1.1
zte(cfg)#ping 192.168.1.1
Reply from 192.168.1.1 : bytes=28 time<1ms TTL=64
Reply from 192.168.1.1 : bytes=28 time<1ms TTL=64
Reply from 192.168.1.1 : bytes=28 time<1ms TTL=64
Reply from 192.168.1.1 : bytes=28 time<1ms TTL=64
Reply from 192.168.1.1 : bytes=28 time<1ms TTL=64
SJ-20130731155059-002|2013-11-27 (R1.0)
enabled 192.168.1.2
Chapter 5 Service Configuration
Figure 5-17.
Mask MacAddress
255.255.255.0 00.d0.d0.fa.29.20
5-67
ZTE Proprietary and Confidential
Function
Displays ipport layer-3 interface
configuration.
Displays all routing information.
Displays hardware routing
configuration.
VlanId
100