Zte ZXR10 2900E series Configuration Manual page 222

ZXR10 2900E Series Configuration Guide
Step
1
2
3
4
5
6
7
8
9
Configuration Example of a Single ERPS Domain
Figure 5-70
configuration is called single-domain, single-ring. The configuration is as follows:
l
Protection instance 1 is configured for the ERPS domain. In this instance, the
dedicated VLAN (VLAN 4000) is used to protect VLANs 100 to 110.
l Switch A is the owner node, and its port 1/2 is an RPL port.
l Switch B is the neighbor node, and its port 1/2 is an RPL port.
SJ-20130731155059-002|2013-11-27 (R1.0)
Command
set ERPS domain <1-4>
ZXR10(config)#
protect-instance <1-16>
set erps domain
ZXR10(config)#
<1-4> ring-id <1-239> raps-vlan
<1-4094>{ring-east {port <portid>| trunk
<portid>} ring-west {port <portid>| trunk
<portid>}}[ rpl-role {owner | neighbour}
rpl-port {east | west}]
set erps domain <1-4>
ZXR10(config)#
ring-mel <1-7>
set erps domain <1-4>
ZXR10(config)#
behaviour {revertive | non-revertive}
set erps domain <1-4>
ZXR10(config)#
timer wtr-time <1-12>
set erps domain <1-4>
ZXR10(config)#
timer guard-time <1-200>
set erps domain <1-4>
ZXR10(config)#
switch {{fs | ms east | west}|clear}
show ERPS brief
show ERPS domain <1-4>
shows that an ERPS domain is configured on switches A to D. This type of
Function
Creates an ERPS domain.
Configures an ERPS ring node.
The raps-vlan parameter should specify a
service-unrelated VLAN (not conflicted with
any of the VLANs for services and network
management). The port PVID must not be
the same as the setting of the raps-vlan
parameter.
The setting of the ring-id parameter is
carried in the protocol message, varying
with the ERPS instance.
Configures the mel for the ring node.
Specifies the reverive or non-revertive
mode for the ring.
Configures the WTR time (in minutes) of
the ERPS ring.
The WTR timer (in minutes) is valid for the
RPL owner node only, range: 1–12, default:
5.
Configures the guard timer time (in units of
10 ms) for the ERPS ring,
Range: 1–200, default: 50.
Configures the manual switching command
for the ERPS ring.
After the FS/MS command is executed, the
corresponding port is set to block status.
Displays the primary configuration of each
ERPS domain.
Displays detailed information about the
ERPS domain.
5-174
ZTE Proprietary and Confidential