Figure 5-70 Configuration Example Of A Single Erps Domain With Multiple Loops - Zte ZXR10 2900E series Configuration Manual

Chapter 5 Service Configuration
l Switches C and D are none nodes.

Figure 5-70 Configuration Example of a Single ERPS Domain with Multiple Loops

The configuration on switch A is as follows:
/*The following commands configure a spanning tree instance:*/
Switch_A(config)#set stp enable
Switch_A(config)#set stp instance 1 add vlan 100-110
/*The following command configures protection instance 1 for the ERPS domain*/
Switch_A(config)#set ERPS domain 1 protect-instance 1
/*The following command configures the owner node. The RPL port is port 1/2. */
Switch_A(config)#set ERPS domain 1 ring-id 1 raps-vlan 4000 ring-east trunk 1
ring-west port 1/2 rpl-role owner rpl-port west
The configuration on switch B is as follows:
/*The following commands configure a spanning tree instance:*/
Switch_B(config)#set stp enable
Switch_B(config)#set stp instance 1 add vlan 100-110
/*The following command configures protection instance 1 for the ERPS domain:*/
Switch_B(config)#set ERPS domain 1 protect-instance 1
/*The following command configures switch B to be a neighbor node*/
/*and its port1/2 to be an RPL port:*/
Switch_B(config)#set ERPS domain 1 ring-id 1 raps-vlan 4000 ring-east port 1/1
ring-west port 1/2 rpl-role neighbour rpl-port west
The configuration on switch C is as follows:
/*The following commands configure a spanning tree instance:*/
Switch_C(config)#set stp enable
Switch_C(config)#set stp instance 1 add vlan 100-110
5-175
SJ-20130731155059-002|2013-11-27 (R1.0) ZTE Proprietary and Confidential