Zte ZXR10 2900E series Configuration Manual page 281

Indicator
↓BW%
PING
CRC
STORM
NoMAC
PoE (valid only for
devices that support
PoE)
Note:
In STA mode, if a port is added to multiple instances, the indicator of the port indicates the
STA state in the first instance.
M_Button Function Mode Switch
1. There is a mode button on the panel. Press it once, and then the indicator for the next
mode (based on the sequence on the switch panel) begins flashing for 2 seconds. If
the button is not pressed in 2 seconds, the mode indicator is off. The device enters this
mode and executes the function of this mode. If the button is pressed in 2 seconds,
the next mode indicator begins flashing. The previous process is repeated.
SJ-20130731155059-002|2013-11-27 (R1.0)
State
On (green)
On (green)
On (yellow)
Off
On (yellow)
On (yellow)
On (yellow)
On (green)
On (yellow)
Off
6-51
Chapter 6 Management
Description
In this mode, a port indicator displays the
current occupation rate of uplink port inbound
bandwidth. The current speed on the uplink
interface is used as the base.
The device sends five ICMP to the network
management center. Each ICMP packet
corresponds to an indicator of a port (port 1–5).
If an indicator is on (green), a response of the
corresponding packet is received.
The device sends five ICMP to the network
management center. Each ICMP packet
corresponds to an indicator of a port (port 1–5).
If an indicator is on (yellow), no response of the
corresponding packet is received.
No IP address is configured for the network
management center.
There is a CRC error frame on the port.
The port is a storm port.
The storm threshold is set to 80 percent of the
automatically negotiated speed on the port.
If the traffic sent and received on the port
exceeds the threshold, the port is a storm port.
The port does not learn a MAC address.
PoE is normal.
PoE is abnormal.
No power.
ZTE Proprietary and Confidential