Chapter 5 Service Configuration
Figure 5-68 Example of the Primary Node Blocking the Secondary Port (Ring Status:
UP)
Figure 5-69 Example of the Primary Node Enabling the Secondary Port (Ring status:
DOWN)
Figure 5-68
shows that each link is operating properly, the ring is in idle status, and the
secondary port of the primary node is blocked. Traffic passes through switches C and D.
Figure 5-69
shows that the link between switches B and C is disconnected. The link status
changes to Protection, and ERPS immediately switches the RPL port of the owner node
to forwarding status. After the switching, traffic does not pass through switches C and D.
After the link between switches C and D is restored, the RPL port of the owner node is
blocked again, and the ring status changes to pending as shown in
Figure
5-68.
Configuring ERPS
To configure ERPS, perform the following steps.
5-173
SJ-20130731155059-002|2013-11-27 (R1.0)
ZTE Proprietary and Confidential