Zte ZXR10 2900E series Configuration Manual page 46

ZXR10 2900E Series Configuration Guide
netmask
/*subnet mask*/
ipaddr
/*local interface address*/
bootfile
/*version file location*/
username
/*username used when the file is downloaded through ftp*/
password
/*password used when the file is downloaded through ftp*/
MAC
/*MAC address of the switch*/
4. Set the IP address of the back-end computer to be the same as that of the TFTP server.
5. Start the TFTP server software on the back-end computer and configure the TFTP by
referring to
6. In ZX10 Boot status, enter zte to enter BootManager status of the switch. Enter ? to
display the command list for this status.
[ZXR10 Boot]:zte
[bootManager]: ?
?
cd
exit
format
ftp
help
l
ls
mv
reboot
rm
setBOOTpassword - set password for BOOT mode
setPtype- set packaged type
show
update
[bootManager]:
7. In BootManager status, run the reboot command to restart the switch and load the
new version file. The following shows how to download the version file from the TFTP
server to the Flash memory:
FTP directory format: ftp get<filename>. The file will be downloaded to the current
directory. If you want to check the current directory, use the ls command. The port
address used by FTP and port information can be modified in the c directory in ZX10
Boot. Take port 1 as an example.
boot location [0:Net,1:Flash]
actport
SJ-20130731155059-002|2013-11-27 (R1.0)
4.2 Configuring the TFTP
- alias for 'help'
- change current path
- exit from bootManager mode
- format flash
- get/put file from/to FTP server
- print online help
- load zImage
- list files in current directory
- change [source] name to [destination] name
- perform REBOOT of the CPU
- remove file
- show board information
- update boot or firmware
: 255.255.255.0
: 10.40.89.79
: /img/zImage
: ZXR10
: ZXR10
: 00:d0:d0:30:20:10
Server.
: 1
: 1
4-14
ZTE Proprietary and Confidential