LACP Basic Information Check
Click Configuration > Lacp > Lacp Port on the left of the main page. The LACP
basic information page is displayed, see
Figure 6-34 LACP Basic Attribute Page
The displayed information is as follows:
Parameter
AdminStatus
LacpPriority
The aggregation port information is as follows:
Parameter
GroupNum
GroupMode
LacpTime
LacpActive
Set basic attributes of "AdminStatus" and "LacpPriority" on this page and set attributes
of "LacpTime" and "LacpActive" of the aggregation port. After setting, click Apply to
complete the configuration.
When setting the same configuration of bulk aggregation port attribute, click the
corresponding check box to select multiple aggregation ports (select Select All to
select all ports), and then click Set. The configuration page of bulk aggregation port
is displayed, see
SJ-20130731155059-002|2013-11-27 (R1.0)
Figure
6-35.
6-41
Chapter 6 Management
Figure
6-34.
Description
LACP enabled or not
LACP priority
Description
Aggregation group number that the
aggregation port belongs to
Aggregation group aggregation mode that the
port belongs to
Aggregation port timeout mode
Aggregation port active/passive mode
ZTE Proprietary and Confidential