Version Download/Upload Through FTP
Start the FTP server, enter file system configuration mode, and back up or recover the
version file and configuration file of the switch through FTP.
For the procedure to download or upload a version file through FTP, refer to the table
below:
Step
1
2
3
Flash Formatting
Caution!
After the Flash memory is formatted, all system software and configurations will be cleared.
For the procedure to format the Flash memory, refer to the table below:
Step
1
2
4.2 Configuring the TFTP Server
The switch version file and configuration file can be backed up or recovered through TFTP.
The TFTP server application software is started at the back end to communicate with the
switch (TFTP client) to implement file backup and recovery. This procedure describes
how to configure the back-end TFTP server using TFTP server software (TFTPD) as an
example.
Steps
1. Run the Tftpd software at the back-end computer. The TFTP server window is
displayed, see
SJ-20130731155059-002|2013-11-27 (R1.0)
Command
config tffs
zte(cfg)#
cd <directory name>
zte(cfg-tffs)#
ftp <A.B.C.D><remote-file-name>{do
zte(cfg-tffs)#
wnload|upload}<local-file-name> username <string>
password <string>
Command
config tffs
zte(cfg)#
format
zte(cfg-tffs)#
Figure
4-1.
Chapter 4 System Management
Function
Enters file system configuration mode.
Formats the Flash.
4-3
ZTE Proprietary and Confidential
Function
Enters file system
configuration mode.
Enters the directory.
Downloads or uploads the
version file through FTP.