Figure 25 802.3Ah Instance Configuration - Zte ZXR10 5900 Series User Manual

Step Command
2 debug ethernet-oam packet interface
ZXR10#
<interface-name>{in|out|dual}type{information|n
otify|reqst-varb|resps-varb|org-spec|all} mode
{all-time|(number [100-1000])}
3 clear ethernet-oam { all |statistic }
ZXR10(config)#
Instance Configuration
As shown in Figure
is gei_1/1, R2 port is gei_1/2.
F 25 802.3 I
IGURE AH
Configuration of remote discovery
Configuration of R1:
ZXR10(config)#set ethernet-oam en
ZXR10(config)#interface gei_1/1
ZXR10(config-gei_1/1)#set ethernet-oam enable
ZXR10(config-gei_1/1)#set ethernet-oam period 10 timeout 3
mode passive
Configuration of R2:
ZXR10(config)#set ethernet-oam enable
ZXR10(config)#interface gei_1/2
ZXR10(config-gei_1/2)#set ethernet-oam enable
ZXR10(config-gei_1/2)#set ethernet-oam period 10 timeout 3 mode active
When discovering sucess, prompt ETH-OAM gei_1/2 discovery
process is successful.
When failing, prompt ETH-OAM gei_1/2 is informed of remote link
fault.
ETH-OAM: gei_1/2 is informed of remote unrecoverable failure.
When discovering sucess, the discovery information showed by R2
is as follows:
ZXR10(config)#show ethernet-oam gei_1/2 discovery
PortId 2 : ethernet oam enabled
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 11 Ethernet OAM Configuration
Function
This prints Ethernet-oam
packet that is in, out or both
on one interface, the type of
packet can be information
PDU, notify PDU, request PDU
,response PDU and so on.
This clears configuration or
statistics data.
Select all to clear all
ethernet-oam configuration.
Select statistic for clearing
all statistic information but
reserving configuration.
25, run ethernet-oam on R1 and R2. R1 port
C
NSTANCE ONFIGURATION
93