Zte ZXR10 2900E series Configuration Manual page 98

ZXR10 2900E Series Configuration Guide
Command
zte(egress-extend-acl)#
source-ipaddr>< sip-mask>| any}[ ssourrce-porrtt < 0-65535><
sport-mask>]{< destination-ipaddr>< dip-mask>| any}[ desstt-porrtt
< 0-65535>< dport-mask>][ dsscp < 0-63>][ fragment]
zte(egress-extend-acl)#
sender-ipaddr>< sip-mask>| any}{< target-ipaddr>< tip-mask>| any}
zte(cfg)#
zte(cfg)#
zte(egress-link-acl)#
< 0-7>][< vlan-id>[< vlan-mask>]][< dest-mac>< dmac-mask>| any]}
zte(egress-link-acl)#
< 0-7>][< vlan-id>[< vlan-mask>]][< dest-mac>< dmac-mask>| any]}
zte(egress-link-acl)#
{[ ether-type < 1501-65535>| dsap-ssap < 0-65535>][ coss
< 0-7>][< vlan-id>[< vlan-mask>]][< source-mac>< smac-mask>|
any][< dest-mac>< dmac-mask>| any]}
zte(egress-link-acl)#
[<vlan-id>[<vlan-mask>]][cos <0-7>][<dest-mac><dmac-mask>|
any]
zte(cfg)#
zte(cfg)#
zte(egress-hybrid-acl)#
deny}< ip-protocol>{< source-ipaddr>< sip-mask>| any}{<
destination-ipaddr>< dip-mask>| any}[ dsscp < 0-63>][ fragment][
coss < 0-7>][< vlan-id>[< vlan-mask>]][< source-mac><
smac-mask>| any][< dest-mac>< dmac-mask>| any]
zte(egress-hybrid-acl)#
source-ipaddr>< sip-mask>| any}{< destination-ipaddr>< dip-mask>|
any}[ dsscp < 0-63>][ fragment][ coss < 0-7>][< vlan-id>[<
vlan-mask>]][< source-mac>< smac-mask>| any][< dest-mac><
dmac-mask>| any]
SJ-20130731155059-002|2013-11-27 (R1.0)
rule < 1-500>{ permit | deny} udp {<
rule < 1-500>{ permit | deny} arp {<
clear egress-acl extend number < 500-599>
config egress-acl link number < 600-699>
rule < 1-500>{ permit | deny} ip {[ coss
rule < 1-500>{ permit | deny} arp {[ coss
rule < 1-500>{ permit | deny} other
rule <1-500>{permit | deny} any
clear egress-acl link number < 600-699>
config egress-acl hybrid number < 700-799>
rule < 1-500>{ permit |
rule < 1-500>{ permit | deny} ip {<
5-50
ZTE Proprietary and Confidential
Function
Sets an extended egress ACL that
matches UDP packets.
Sets an extended egress ACL that
matches ARP packets.
Clears an extended egress ACL
instance.
Creates a layer-2 egress ACL
instance and configures it.
Sets a layer-2 egress ACL that
matches IP packets.
Sets a layer-2 egress ACL that
matches ARP packets.
Sets a layer-2 egress ACL that
matches packets except IP/ARP
packets.
Sets the rule that a layer-2 egress
ACL is used to match packets with
specified cos, VLAN id, and dmac
flags.
Clears a layer-2 egress ACL
instance.
Creates a hybrid egress ACL
instance and configures it.
Sets a hybrid egress ACL that
matches specified fields of IPv4
packets.
Sets a hybrid egress ACL that
matches IPv4 packets.