Zte ZXR10 2900E series Configuration Manual page 211

Note:
The DHCP client and the DHCP server are in different network segments.
l
Configuration Procedure
1. Assign a specified VLAN to the port:
set vlan 1000 add port 2 tag
set vlan 1000 enable
2. Configure the DHCP relay by using the following commands:
zte(cfg)#set dhcp relay enable
zte(cfg-router)#set ipport 0 ipaddress 169.1.15.1 255.255.0.0
zte(cfg-router)#set ipport 0 vlan 1
zte(cfg-router)#set ipport 0 enable
zte(cfg-router)#set ipport 0 dhcp relay agent
zte(cfg-router)#set ipport 0 dhcp relay server 10.230.72.2
zte(cfg-router)#set ipport 63 ipaddress 10.230.72.1 255.255.255.0
zte(cfg-router)#set ipport 63 vlan 1000
zte(cfg-router)#set ipport 63 enable
l Configuration Verification
zte(cfg)#show dhcp relay
DHCP relay status
DHCP server mode
DHCP server retry
DHCP relay option82:
zte(cfg)#show dhcp relay option82 port 1
DHCP option82 sub-option information on port 1:
Circuit-ID: Disabled
Remote-ID: Enabled
Format: Cisco
DHCP option82 mode information on port 1: Default
zte(cfg)#show ipport 0
Status
VlanId
ArpProxy
Timeout
En/Disable: enabled
Dhcp client configuration as follows:
Class-id
Client-id
Hostname
SJ-20130731155059-002|2013-11-27 (R1.0)
: enable
: ipport
: 10
disable
: up IpAddress : 169.1.15.1
: 1 Mask
: disabled MacAddress: 00.00.00.11.22.33
: 600(s) IpMode
: -
: -
: -
5-163
Chapter 5 Service Configuration
: 255.255.0.0
: static
ZTE Proprietary and Confidential