Zte ZXR10 2900E series Configuration Manual page 85

The STP configuration includes the following commands:
Command
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
HUAWEI | HAMMER | extend }
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
HUAWEI | HAMMER | extend }
zte(cfg)#
zte(cfg)#
HUAWEI}<0x00..0-0xff..f>
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
SJ-20130731155059-002|2013-11-27 (R1.0)
set stp {enable | disable}
set stp forceversion {mstp | rstp | stp}
set stp port <portlist>{enable | disable}
set stp port <portlist> linktype {point-point | shared}
set stp port <portlist> packettype {IEEE | CISCO |
set stp port <portlist> pcheck
set stp port <portlist> bpdu-guard {enable | disable}
set stp bpdu-interval <10-65535>
set stp trunk <trunklist>{enable | disable}
set stp trunk <trunklist> linktype {point-point | shared}
set stp trunk <trunklist> packettype {IEEE | CISCO |
set stp edge-port {add | delete} port <portlist>
set stp {hmd5-digest | hmd5-key}{CISCO |
set stp hellotime <1-10>
set stp forwarddelay <4-30>
set stp agemax <6-40>
set stp hopmax <1-40>
set stp name <name>
set stp revision <0-65535>
Chapter 5 Service Configuration
5-37
ZTE Proprietary and Confidential
Function
Enables or disables the STP.
Sets the forced STP type to
MSTP/RSTP/STP.
Enables or disables the port STP
function.
Sets port connection type.
Sets instance port packet type.
Checks the current STP protocol
type and selects the best protocol.
Enables or disables the BPDU
packet protection function on the
port.
Sets an interval for BPDU
protection recovery.
Enables trunk/disables the STP
function.
Sets trunk connection type.
Sets packet types sent and
received by the trunk.
Adds/deletes STP edge port.
Sets hmd5 parameter when the
device is connected with CISCO
or HUAWEI.
Sets STP notification interval.
Sets STP forwarding delay time.
Sets STP aging time
Sets the maximum number of hops
between edge equipment and root
switch of MSTP.
Sets the name of the MSTP
domain.
Sets the revision level of the
MSTP.