Figure 5-36 Pppoe-Plus Configuration Instance Topology - Zte ZXR10 2900E series Configuration Manual

Configuring PPPoE-PLUS
The configuration of PPPoE-PLUS (PPPoE+) includes the following contents:
Command
zte(cfg)#
zte(cfg)#
cisco | china-tel | manual <string>| key <string>}
zte(cfg)#
show pppoe-plus (all configuration modes)
show pppoe-plus port <1-28> (all configuration modes)
zte(cfg)#
modify }
PPPoE-PLUS Configuration Instance
l Configuration Description
Configure the user information format of switch A as DSL forum format. See
5-36.

Figure 5-36 PPPOE-PLUS Configuration Instance Topology

l
Configuration Procedure
Configure switch A
zte(cfg)#set pppoe-plus enable
zte(cfg)#set pppoe-plus tag-format port 1 dsl-forum
l
Configuration Verification
zte(cfg)#show pppoe-plus
PPPoE plus is enabled.
zte(cfg)#show pppoe-plus port 1
PPPoE Vendor-Specific Tag format on port 1:DSL-Forum
PPPoE-PLUS option mode information on port 1: Default
PPPoE VST remote ID on port 1 has not been set.
SJ-20130731155059-002|2013-11-27 (R1.0)
set pppoe-plus {enable | disable}
set pppoe-plus tag-format port <portlist>{dsl-forum |
set pppoe-plus rid <portlist>[<string>]
set pppoe-plus mode port <portlist>{default | drop |
Chapter 5 Service Configuration
5-107
ZTE Proprietary and Confidential
Function
Enables or disables the PPPoE+
function.
Sets the PPPoE+ location
message format.
Adds or deletes port rid
information.
Displays PPPoE+ global
configuration.
Displays port rid configuration.
Sets the mode for dynamic user
information processing at the port.
Figure