Zte ZXR10 2900E series Configuration Manual page 242

ZXR10 2900E Series Configuration Guide
Command
zte(cfg)#
part}<mode><key1-string>[<key2-string>[... <key10-string>]]
zte(cfg)#
show privilege {default | level [<0-15>]| session [<1-1024>]} (for
all configuration modes)
Privilege Configuration Instance
l
Configuration Description
Users can perform this configuration only when logging in to the switch with the highest
permission (level 15).
l
Configuration Procedure
Configure the switch:
/*Enable the privilege function*/
zte(cfg)#privilege enable
/*Grant level-12 permission to all functions of the set node*/
zte(cfg)#privilege 12 session 1 part cfg set
l
Configuration Verification
1. Execute the following commands to check the command permission rule.
zte(cfg)#show privilege session
State: Enable
User level: 15
Session Level Type Mode
------- ----- ---- ------------- -----------------
2. Log in to the switch and execute the related set command as a user with a lower
permission (for example, level 11).
Execute the
user is disallowed to execute the command.
The user privilege(level 11) is less than command privilege(level 12 rule 1).
Log in to the switch as a user with a permission higher than or equal to the
permission (for example, level 13) and execute the same command.
command can be properly executed, without the prompt mentioned above.
SJ-20130731155059-002|2013-11-27 (R1.0)
privilege <0-15> session <1-1024>{all |
clear privilege session [<1-1024>]
1 12 part cfg
set stp enable command. The system will prompt that the
zte(cfg)#
% Command cannot be performed because of insufficient privilege. (0x40000aab)
Key
set
6-12
ZTE Proprietary and Confidential
Function
Sets the command permission.
Clears a specified command
permission rule.
Displays a specified command
permission rule.
The