Syslog Configuration; Figure 5-29 Vlan Mapping Configuration Instance - Zte ZXR10 2900E series Configuration Manual

The port 1 is on customer network, and the port 24 is on service provider network, see
Figure
1-100, to SPVLAN 1000.

Figure 5-29 VLAN Mapping Configuration Instance

Switch1 and Switch2 are configured in the same way. Use Switch1 as an example.
l
Configuration Procedure
The following example shows how to configure the VLAN Mapping instance.
zte(cfg)#set vlan 1-100,1000 add port 1,24 tag
zte(cfg)#set vlan 1-100,1000 enable
zte(cfg)#set vlan mapping session 1 customer-port 1 customer-vlan 1-100
uplink-vlan 1000
l
Configuration Verification
The following example shows how to show the SVLAN instance.
zte(cfg)#show vlan mapping
Session number
Customer Port
Customer Vlan List : 1-100
Uplink Vlan

5.24 Syslog Configuration

Syslog Overview
The Syslog protocol is an important part of Ethernet switch and is the information junction
center of system software module. Syslog manages most of important information output
and classifies them in detail, which filters the information effectively and provides a strong
support for network administrators and development engineers in monitoring network
operation status and diagnosing network faults.
SJ-20130731155059-002|2013-11-27 (R1.0)
5-29. Map the packets received from port 1, and whose CVLANs are between
: 1
: 1
: 1000
Chapter 5 Service Configuration
5-89
ZTE Proprietary and Confidential