Zte ZXR10 2900E series Configuration Manual page 198

ZXR10 2900E Series Configuration Guide
l Loopback Message (LBM): A unicast CFM protocol data unit. It is sent to a specified
MP from an MEP, expected to receive an LBR message.
l
Loopback Reply (LBR): A unicast CFM protocol data unit. It is sent by the MP receiving
an LBM as the reply to the LBM.
With the five protocol messages listed above, CFM implements the following functions:
l
Detecting faults: MEP detects network connectivity faults by periodically sending
and receiving CCM messages. The faults include connection failure and unwelcome
connection (error connection).
l
Notifying faults: After MEP detects a connectivity fault, it sends a proper alarm to the
specified management system, for example, trap messages of SNMP.
l
Locating a path: MEP locates and traces a path from an MEP to another MP (including
MEP and MIP) by using LTM/LTR messages.
l Confirming and separating a fault: This is an administrative function. The network
manager confirms the fault through LBM/LBR messages and separates the fault.
Configuring a 802.1AG Command
802.1AG configuration includes the following commands:
Command
zte(cfg)#
zte(cfg)#
<0-7>
zte(cfg)#
name <string>
zte(cfg)#
mep-session <1-64> mep-id <1-8191> direction {down|up}
zte(cfg)#
mip-session <1-64> name <string>
zte(cfg)#
rmep-session <1-64> rmep-id <1-8191> remote-mac
<hh.hh.hh.hh.hh.hh>
zte(cfg)#
primary-vlan {<1-4094>| delete}
zte(cfg)#
time-interval <4-7>
zte(cfg)#
md-name {absent | disable | present}
zte(cfg)#
<1-8191> state {disable|enable}
SJ-20130731155059-002|2013-11-27 (R1.0)
cfm {disable|enable}
create cfm md-session <1-16> name <string> level
create cfm md-session <1-16> ma-session <1-32>
create cfm md-session <1-16> ma-session <1-32>
create cfm md-session <1-16> ma-session <1-32>
create cfm md-session <1-16> ma-session <1-32>
cfm md-session <1-16> ma-session <1-32>
cfm md-session <1-16> ma-session <1-32> ccm
cfm md-session <1-16> ma-session <1-32> ccm
cfm md-session <1-16> ma-session <1-32> mep-id
5-150
ZTE Proprietary and Confidential
Function
Enables/disables the CFM
function.
Creates a CFM md.
Creates a CFM ma.
Creates a CFM local mep.
Creates a CFM mip.
Creates a CFM remote mep.
Sets or delete the primary VLAN
within cfm ma.
Sets the interval that ccm packets
of mep within cfm ma are sent.
Sets the way to fill in the MEG ID
field in a cfm ccm messages.
Sets the status of the cfm mep
protocol.