Login Username Or Password Lost - Zte ZXR10 2900E series Configuration Manual

5. The switch did not enable the Web management function.
Solution
1. Upgrade the browser version on the local computer to at least IE 6.0.
2. Check the switch configuration to obtain a correct IP address and port number.
3. Check the line between the local computer and the switch to ensure that the
communication is normal.
4. Configure a correct management port and IP address for the switch.
5. Enable the Web management function of the switch and set a port number.

7.3.5 Login Username or Password Lost

Symptom
A user cannot log in to the switch after entering the username and password.
Fault Analysis
The username or password used to log in to the switch is incorrect.
Solution
First of all, confirm whether the system administrator can find the original username and
password. If the system administrator cannot find the original username and password,
reboot the switch and delete the configuration file. The operation procedure is as follows:
1. Reboot the switch and press any key on the HyperTerminal to enter the boot state.
ZXR10 2928E BootRom Version v1.15
Compiled May 21 2012 08:57:22
Copyright (c) 2010 by ZTE Corporation.
boot location [0:Net,1:Flash] : 1
actport
serverip
netmask
ipaddr
bootfile
username
password
MAC
Press any key to stop autoboot:
[ZXR10 Boot]:
2. In [ZXR10 Boot] state, enter [ZXR10 Boot]:zte to enter [BootManager] state of the
switch. Enter <?> for command help.
[BootManager]: ?
?
SJ-20130731155059-002|2013-11-27 (R1.0)
- alias for 'help'
: 1
: 10.40.89.78
: 255.255.255.0
: 10.40.89.79
: /img/zImage.B10
: ZXR10
: ZXR10
: 00:d0:d0:29:28:01
2
7-5
ZTE Proprietary and Confidential
Chapter 7 Maintenance