Figure 5-26 Sqinq Configuration Instance - Zte ZXR10 2900E series Configuration Manual

Configuring SQinQ
The SQinQ configuration includes the following commands:
Command
zte(cfg)#
<port-id> customer-vlan <vlan-list> uplink-vlan <vlan-id>
zte(cfg)#
zte(cfg)#
show vlan sqinq (all configuration modes)
show vlan sqinq session <1-400> (all configuration modes)
SQinQ Configuration Instance
l
Configuration Description
Port 1 is a customer port, and port 2 is an uplink port. When CVLAN is 10 and 12, the
packet from port 1 SPVLAN is 997 and 998 respectively. See

Figure 5-26 SQinQ Configuration Instance

l
Configuration Procedure
Configure the SVLAN instance.
zte(cfg)#set vlan 10,12 add port 1 tag
zte(cfg)#set vlan 997,998 add port 1 untag
zte(cfg)#set vlan 997,998 add port 2 tag
zte(cfg)#set vlan 10,12,997,998 enable
zte(cfg)#set vlan sqinq session 1 customer-port 1 customer-vlan 10 uplink-vlan 997
zte(cfg)#set vlan sqinq session 2 customer-port 1 customer-vlan 12 uplink-vlan 998
l
Configuration Verification
The following example shows how to show the SVLAN instance.
SJ-20130731155059-002|2013-11-27 (R1.0)
set vlan sqinq session <1-400> customer-port
clear vlan sqinq
clear vlan sqinq session <1-400>
Chapter 5 Service Configuration
5-83
ZTE Proprietary and Confidential
Function
Enables SVLAN function.
When the SQinQ function is
enabled, the uplink traffic is
normally forwarded in SPVLAN.
The downlink traffic is normally
forwarded in SPVLAN. Because
the UNI port belongs to SPVLAN
in untagged mode, the SPVLAN
tag of downlink packets will be
removed.
Deletes all SQinQ sessions.
Deletes the specified SQinQ
session.
Displays all SQinQ sessions.
Displays the specified SQinQ
session.
Figure 5-26.