Zte ZXR10 2900E series Configuration Manual page 136

ZXR10 2900E Series Configuration Guide
Mapping Modes:
Uplink: replace the CVLAN with SVLAN based on "Interface+customer VLAN".
Downlink: replace the SVLAN in the outermost layer with CVLAN based on "SVLAN +
Destination MAC address".
The whole system supports 400 sessions, and up to 400 CVLANs can be supported.
Configuring VLAN Mapping
The VLAN mapping configuration includes the following commands:
Command
zte(cfg)#
<port-id> customer-vlan <vlan-list> uplink-vlan <vlan-id>
zte(cfg)#
zte(cfg)#
zte(cfg)#
zte(cfg)#
show vlan mapping (all configuration modes)
show vlan mapping session <1-400> (all configuration modes)
show vlan mapping user-table (all configuration modes)
show vlan mapping user-table session <1-400> (all configuration
modes)
VLAN Mapping Configuration Instance
l
Configuration Description
SJ-20130731155059-002|2013-11-27 (R1.0)
set vlan mapping session <session_id> customer-port
clear vlan mapping
clear vlan mapping session <1-400>
clear vlan mapping user
clear vlan mapping user session <1-400>
5-88
ZTE Proprietary and Confidential
Function
Sets the VLAN Mapping function.
When the VLAN Mapping is
enabled, the uplink traffic is
normally forwarded in SPVLAN.
The downlink traffic is normally
forwarded in SPVLAN. When
reaching the user port, it is
transformed to the corresponding
CVLAN tag.
Deletes all VLAN Mapping
sessions.
Deletes the specified VLAN
Mapping session.
Deletes the user information of all
VLAN Mapping sessions.
Deletes the user information of the
specified VLAN Mapping session.
Displays all VLAN Mapping
sessions.
Displays the specified VLAN
Mapping session.
Displays the user information of all
VLAN Mapping sessions.
Displays the user information
of the specified VLAN Mapping
session.