Telnet - Zte ZXR10 2900E series Configuration Manual

ZXR10 2900E Series Configuration Guide
2. In a mode, if the mode button is not pressed in 3 minutes, the device exits from this
mode automatically to the LINK mode. If the button is pressed, the device enters the
next mode. The corresponding mode indicator begins flashing, which is as described
in 1.
3. In the PING mode, a ping packet is sent once per 20 seconds. In other modes, the
statuses are updated in real time.

6.10 Telnet

Telnet Overview
As a member of the TCP/IP protocol family, the Telnet protocol is the standard protocol for
the remote Internet login service. With this protocol, users can perform operations on a
remote switch through a local PC.
A ZTE switch can be used as both a Telnet client and a Telnet server.
User can set the listening port number when the device is logged in to through Telnet, also
user can set the port number and source IP address when the device is used as a Telnet
client to log in to another device.
Telnet Configuration
The Telnet configuration includes the following commands:
Command
zte(cfg)#
zte(cfg)#
ip-addr>
zte(cfg)#
show Telnet (for all configuration modes)
Telnet Configuration Instance
l
Configuration Description
See
the IP address of the PC is 192.168.1.100/24. The PC remotely logs in to the switch
through Telnet.
SJ-20130731155059-002|2013-11-27 (R1.0)
set Telnet server {enable | disable}
telnet <dest ip-addr> destination-port <port-num><src
set telnet listen-port <port>
Figure 6-48, a switch has a layer-3 port with the IP address 192.168.1.1/24, and
6-52
ZTE Proprietary and Confidential
Function
Enables or disables the Telnet
server function, which is enabled
by default.
Sets the port number and source
IP address when the device is
used as a Telnet client to log in to
another device.
Sets the listening port number
when the device is logged in to
through Telnet. The value is 23 or
between 1025 and 49151.
Displays the Telnet configuration
and status.