Zte ZXR10 2900E series Configuration Manual page 178

ZXR10 2900E Series Configuration Guide
/*the local is the active originator (Master).
The other end displays as slave.*/
zte(cfg)#set ethernet-oam remote-loopback port 2 stop
/*disable OAM remote-loopback on port2.
Key points of configuration:
The switch gives the following prompts when OAM discovery failure occurs, or starting
and stopping remote loopback.
OAM discovery is completed successfully on port 2, the following information appears.
SAT JUL 03 23:30:00 2004 ETH-OAM port 2's discovery process is successful.
Disconnect the network cable between switches, the following information appears.
SAT JUL 03 23:33:00 2004 ETH-OAM port 2 deteced
a fault in the local receive direction.
OAM Link Control Event Configuration Instance
l
Configuration Description
OAM monitor function can notify the abnormal frame of the link receiver to the local.
The function is based on OAM discovery. See
switch A through console port and configures OAM. Enable OAM and the port link
monitor of the switch B. Then the error frame and the error symbol can be detected
and announced to local switch A.
SJ-20130731155059-002|2013-11-27 (R1.0)
Stable : yes
Discovery : done
Loopback : on(Master)
PDU Revision : 1431
Remote DTE
-----------
Config:
Mode : active
Link Monitor : support
Unidirection : nonsupport
Remote Loopback : support
Mib Retrieval : nonsupport
PDU max size : 1518
Status:
Parser : loopback
Multiplexer : discard
Stable : yes
Mac Address : 00.d0.d0.29.28.02
PDU Revision : 28
The switch replies OAM discovery success.*/
/*the parser state is loopback*/
/*the multiplexer state is discard*/
Figure
5-130
ZTE Proprietary and Confidential
5-46, the user logs in to the