Figure 5-45 Remote Loop Network - Zte ZXR10 2900E series Configuration Manual

ZXR10 2900E Series Configuration Guide
Command
show ethernet-oam (all configuration modes)
show ethernet-oam port (all configuration modes)
show ethernet-oam port <portlist> discovery (all configuration
modes)
show ethernet-oam port <portlist> statistics (all configuration
modes)
show ethernet-oam port <portlist> link-monitor (all configuration
modes)
OAM Remote Loopback Configuration Instance
l
Configuration Description
OAM remote loopback is used to locate failure and examine the link performance.
The function is based on OAM discovery. See
switch A through console port and configures OAM, Enable OAM and the port remote
loopback of the other end. When remote switch B is on the OAM remote loopback
mode, the statistic data of local and remote switch can be inquired and compared at
any time. OAM loopback frame can be analyzed to obtain the additional information
of link health (frame discard due to the link failure).

Figure 5-45 Remote Loop Network

l
Configuration Procedure
1. Configuration of switch A:
zte(cfg)#set ethernet-oam en
zte(cfg)#set ethernet-oam port 1 en
2. Configuration of switch B:
zte(cfg)#set ethernet-oam enable
zte(cfg)#set ethernet-oam port 2 enable
zte(cfg)#show Ethernet-oam port 2 discovery
/*the port mode must be active, or the discovery is failure*/
SJ-20130731155059-002|2013-11-27 (R1.0)
PortId 2: ethernet oam enabled
Local DTE
-----------
Config:
Mode : active
Figure
/*the local device information*/
5-128
ZTE Proprietary and Confidential
Function
Displays OAM global configuration
information.
Displays OAM port summary
information.
Displays port OAM discovery
state.
Displays port OAM statistics
information.
Displays port OAM link event
configuration and state.
5-45, the user logs in to the