Command Abbreviations - Zte ZXR10 2900E series Configuration Manual

mac-based-vlan
nas
router
snmp
tffs
Note:
A space must be entered before the question mark (?).
4. If a wrong command, keyword, or parameter is entered, and the Enter key is pressed,
a message "Command not found" is displayed. For example,
zte(cfg)#conf ter
% Command not found (0x40000034)
In the following example, the online help is used to create a username.
zte(cfg)#cre?
zte(cfg)#create ?
acl
cfm
port
protocol-protect
user
vlan
zte(cfg)#create user
% Parameter not enough (0x4000003f)
zte(cfg)#create user ?
<string>
user name(maxsize:15)
zte(cfg)#create user houyx ?
admin
guest
zte(cfg)#create user houyx guest ?
<cr>
<0-15>
zte(cfg)#create user houyx guest
zte(cfg)#
<cr>

Command Abbreviations

In the ZXR10 2900E, a command or keyword can be abbreviated as a character or string
that uniquely identifies this command or keyword. For example, the command exit can be
abbreviated as ex, and the command show port abbreviated as sh por.
SJ-20130731155059-002|2013-11-27 (R1.0)
enter mac-based vlan config mode
enter nas config mode
enter router config mode
enter SNMP config mode
enter file system config mode
create descriptive name for acl
create CFM information
create descriptive name for port
create a rule for protocol protect
create a user
create descriptive name for vlan
create an administrator
create a guest
specify user's priviledge
3-13
Chapter 3 Usage and Operation
ZTE Proprietary and Confidential