Replace The Hydraulic Tank Filter; Replace The Drive Loop Hydraulic Filter - Genie S-65 Service Manual

Service Manual - Second Edition
800-610-4101
ActionRental.com
4 Remove the plug from the side of the torque
hub. Then drain the oil from the hub.
5 Install the torque hub. Torque the hub mounting
bolts to 180 foot-pounds (244 Newton meters).
6 Install the brake and motor onto the torque hub.
7 Fill the hub with oil from the side hole until the
oil level is even with the bottom of the hole.
Apply pipe thread sealant to the plugs, and then
install the plugs.
8 Adjust turntable rotation gear backlash. See
Repair Procedure 12-1, How to Adjust the
Turntable Rotation Gear Backlash.
Turntable rotate torque hub
Oil capacity
Type: SAE 90 multipurpose hypoid gear oil - API
service classification GL5
C-6

Replace the Hydraulic Tank Filter

Replacement of the hydraulic tank filter is
essential for good machine performance and
service life. A dirty or clogged filter may cause the
machine to perform poorly and continued use may
cause component damage. Extremely dirty
conditions may require that the filter be replaced
more often.
Beware of hot oil. Contact with
hot oil may cause severe burns.
Perform this procedure with the
engine off.
1 Remove the filter with an oil filter wrench.
2 Apply a thin layer of oil to the new oil filter
gasket.
3 Install the new filter (Genie part no. 46014) and
tighten it securely by hand. Clean up any oil
that may have spilled during the installation
procedure.
Part No. 48412
Section 4 - Scheduled Maintenance Procedures
4 Use a permanent ink marker to write the date
and number of hours from the hour meter on
the oil filter.
5 Start the engine from the ground controls.
6 Inspect the filter and related components to
be sure that there are no leaks.
C-7
Replace the Drive Loop
Hydraulic Filter
Replacing the drive loop hydraulic filter is essential
to good machine performance and service life. A
dirty or clogged filter may cause the machine to
17 fluid ounces
perform poorly and continued use may cause
0.51 liters
component damage. Extremely dirty conditions
may require that the filter be replaced more often.
1 Open the engine side turntable cover and locate
the drive loop hydraulic filter mounted on the
engine near the main pump.
2 Remove the filter housing by using a wrench on
the nut provided on the bottom of the housing.
3 Remove the filter element from the housing.
4 Inspect the housing seal and replace it if
necessary.
5 Install the new filter (Genie part no. 20880) and
hand tighten the housing onto the filter head.
Clean up any oil that may have spilled during
the installation procedure.
6 Start the engine from the ground controls.
7 Inspect the filter assembly to be sure that there
are no leaks.
8 Clean up any oil that may have spilled.
Genie S-60 & Genie S-65
TABLE C PROCEDURES
Beware of hot oil. Contact with
hot oil may cause severe burns.
Perform this procedure with the
engine off.
4 - 33