Upgrading To High Capacity - Avaya CallPilot 1005r Maintenance And Diagnostics

19. Hold the PCI riser assembly by the two blue handles (A) and push the assembly
Figure 47: PCI riser assembly rear studs and slots
20. Reconnect all MPB96 cables. If you are replacing an NTRH40AA MPB96 with an
21. Reconnect the SCSI cable to the RAID card
22. Replace the chassis cover.
23. Take the ESD strap off.
24. Power up the server and log on to Windows.
25. Run the Configuration Wizard to configure the new hardware.
26. Test the multimedia channels to ensure the new MPB96 board is functioning

Upgrading to high capacity

This section describes how to upgrade your server hardware to the high capacity configuration.
You need three MPB96 boards to support the high capacity feature.
For more information about MPB96 board versions and cables see
processing boards
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
into the server board. Refer to
Important:
If the PCI riser assembly is not fully seated, the server can malfunction.
NTRH40CA, see Meridian 1 and CallPilot Server Configuration (NN44200-302) or
CS1000 and CallPilot Server Configuration (NN44200-312) for information about
connecting the DS30 cables.
For instructions, see Meridian 1 and CallPilot Server Configuration (NN44200-302)
or CS1000 and CallPilot Server Configuration (NN44200-312).
Result: The MPB96 board replacement is complete.
properly.
For instructions, see "Testing the CallPilot installation" in the Installation and
Configuration Task List (NN44200-306).
on page 104.
Figure 42: PCI riser card assembly
Upgrading to high capacity
on page 110.
Locating the voice
December 2010 113