Data -> Igmp Mng - Alcatel-Lucent 1850 TSS-320 User Provisioning Manual

Menu bar
............................................................................................................................................................................................................................................................
Figure 3-31
The page is made up of one panel and one table.
The available parameters in the VLAN Range panel are:
– From: and To: a range of VLAN-Id to be searched can be defined, the range
The panel has the following hyperlinks:
– Cancel: To close the page and go back to the previous page.
– Search: To start the searching procedure.
Group Segregation Mng
The function of this option is to set the segregation state, in order to exclude the Port from
the exchanging of frames with a given list of ports. Only ETB ports in case of
MAC/Virtual Bridge, ETB and ETS ports for Provider Bridge case. In case of Virtual or
Provider Bridge, the ports to be segregated can be also registered over the same VLAN. In
this way a segregated port can exchange frames only with a non-segregated port.
Note: Segregation is applicable also for Link Aggregation Groups.
This function is used to save band and resources on the node and on the ports, and also to
improve the security and the privacy of the transmission.
From the application menu bar, select Data -> Group Segregation Mng and the
following page appears.
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
Data -> IGMP Mng
cannot be greater than 50; default is 1 to 50. Subsequently, after clicking on Search
hyperlink, the VLAN's already associated to an IGMP instance are displayed in
the table.
Data menu
3 - 3 9