Tree area
............................................................................................................................................................................................................................................................
– O PM for Optical analog parameters is configured (only for OC-192)
Clicking on the Default hyperlink it is possible to set the default value ALL.
•
– ALL
– RCV Receive direction for OT port
– TRMT Transmit direction for OT port (egress signal monitoring)
•
– ON PM for the specified Mode Type is enabled
– OFF PM for the specified Mode Type is disabled.
Clicking on the Default hyperlink it is possible to set the default value ON.
The panel has the Save hyperlink by means of which it is possible to store the settings.
The Retrieve Performance Monitoring Mode page allows to retrieve the mode of PM
data collection for the specified facility by:
•
•
– Near End
– Far End
– All
Clicking on the Default hyperlink it is possible to set the default value ALL.
•
– ALL
– RCV Receive direction for OT port
– TRMT Transmit direction for OT port (egress signal monitoring)
PROTECTION functional tab
The PROTECTION functional tab is made up of two panels:
Port Panel
•
UPSR Panel
•
The PROTECTION tab displays the following functional tabs as shown in
............................................................................................................................................................................................................................................................
4 - 44
Direction: (only for OC-192 port) The combo-box allows to specify the direction
of the signal being monitored. The allowable choices are:
PM State: The combo-box allows to set whether the PM data collection for the
specified mode type is enabled or disabled. The allowable choices are:
Access Identifier: The entry box specifies the identifier of the unit resource. It is
also shown in the tree.
Location: The combo-box allows to specify the PM registers location to be
initialized. The allowable choices are:
Direction: (only for OC-192 port) The combo-box allows to specific the direction
of the signal being monitored. The allowable choices are:
Access a resource
Figure
4-26.
8DG08136EAAA
Issue 3 July 2009