Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 233

Tree area
............................................................................................................................................................................................................................................................
Configure IGMP functional tab
Figure 4-32 Configure IGMP
The Configure IGMP functional tab displays IGMP Configuration panel which has the
following parameters:
Port ID: The entry box shows a number assigned by the system; it is the identifier of
•
the physical port on the front of the PIM. The allowable value is: <8 digit number>.
Port Label: The entry box specifies the label of the resource. It is also shown in the
•
tree.
VLAN ID: It permits to choose the VLAN to be associated to the IGMP instance.
•
Clicking on the Select hyperlink the relevant procedure starts.
In order to "bind" a VLAN-IGMP to the selected Port (i.e. using the Port for IGMP
Multicast traffic), and to set the IGMP parameters for the Port, the panel presents these
options:
Fast Leave Section - Fast Leave Per Port: Possible values:
•
•
•
Static Router Section - Static Router Per Port: Possible values:
•
•
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
enabled means that this Port permits the FastLeave, i.e. the removal of the
Multicast traffic on this Port, upon receiving a single "Leave Report" from a user
connected on this Port.
Note: This type of Leave procedure is advisable to be used when only one single
user is connected behind the selected VLAN on that port.
disabled means that this Port does not permit the FastLeave procedure. In this case
the Router has to send some queries in order to check if other members of the
IGMP group registered on this Port are interested in the Multicast transmission.
enabled means that this Port is statically connected to the IP Multicast Router.
Access a resource
4 - 5 5