Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 140

Menu bar
............................................................................................................................................................................................................................................................
The secondary backup database can be copied to the primary backup database. After an
FLC restart (or FLC switch) the memory database will be reloaded from the restored disk
database.
The secondary backup database can be copied to/from a Remote File Server (RFS) by
operator commands (remote backup and remote restore).
The NE supports autonomous reporting of memory database changes, in particular,
changes to provisioning state of the equipment and the facilities.
The NE meets the DB requirements from GR-472-CORE and other applicable standards.
This menu option contains the following sub-options:
DataBase - For Database management.
•
Remote File - For Database from Remote File Server management.
•
Network Element - For retrieving general system level configuration information.
•
Set Site Identifier - For setting the Site Identifier (SID) code that is compared to any
•
Target Identifier (TID) value.
Database
This menu option contains the following options:
Perform DB Backup - It backs up the primary backup data base to the secondary
•
backup data base.
Cancel DB Backup - It cancels a database backup currently in progress.
•
Restore DB - It copies the backup database stored on secondary backup database to
•
the primary backup database and resets the system to activate the new database
DB Information - It reads the database label of the selected backup database stored
•
on the NE
Perform DB backup
This option backs up the whole NE provisioning and configuration database, excluding
Performance Monitoring History Data, current alarm situation, and event log data; in
addition to the database, also writes the system type, the software release identifier, the
site identifier, the backup date and time stamp to the secondary backup database.
The system also writes a CRC (Cyclic Redundancy Check) to the secondary backup
database.
This option returns COMLPD if the process of backup creation has been started on the
NE. The actual completion of the backup process (either successful, or being cancelled, or
with an error) is notified to the operator.
If the creation failed, the system sets the DBF condition. A DBF condition is cleared by
successfully completing a subsequent action or Restore DB option. No DBF condition is
raised if the backup creation was cancelled by the operator.
............................................................................................................................................................................................................................................................
3 - 80
System management menu
8DG08136EAAA
Issue 3 July 2009